<FlowDocument xmlns="http://schemas.microsoft.com/winfx/2006/xaml/presentation"
              xmlns:x="http://schemas.microsoft.com/winfx/2006/xaml"
              xmlns:b="http://schemas.byk.com/2009/xaml/presentation"
			        Tag="Measure Standards">
  

  <Paragraph>• The screen shows the average values of the standard. If the standard was measured by 
               more than one instrument group (e.g. BYK-mac and BYK.mac i) the data of all instrument
               groups are shown. Trafo mode is automatically activated with the latest model being 
               selected as the Trafo Reference. Trafo Mode allows converting readings of one instrument 
               group into readings of another group in order to make the instruments read alike.
  </Paragraph>
 
  <Paragraph>• The standard name now also appears in the tree structure on the left side. Measurements
               taken with the BYK-mac i are by default shown as "fluorescent compensated" (Comp).
  </Paragraph>
 
  <Paragraph>• You can continue measuring standards with the button <Bold>Create Standards</Bold> or
               start to measure samples with the button <Bold>Create Test Series</Bold>.
  </Paragraph>
  <Paragraph>• To change the properties of a standard, click on the button <Bold>Properties</Bold>.
  </Paragraph>
  <Paragraph>• To save the project with the same name, click on the button <Bold>Save Project</Bold>.
  </Paragraph>
    <Paragraph>• To save the project with a new name, click on the button <Bold>Save as</Bold>.
  </Paragraph>
    <Paragraph>• The button <Bold>Close</Bold> takes you back to the Project Selection window.
  </Paragraph>
  
  
    <Paragraph>  </Paragraph>
    <Paragraph>  </Paragraph>
 
</FlowDocument>